Just a heads up about a problem i am dealing with with my Robobrew Gen 3. A fellow home brew club member who owns a RB told me about his unit overheating inside where the circuit boards are. He showed me a picture of the discolored soldering on his main board. I pulled mine apart and could smell the fried board before i got the bottom off. Mine looked just like his with cooked soldering plus a scorched place on the reverse side. Good thing i did not use it again before checking. It would of gotten ugly when it started smoking and reeking of burnt plastic. So take a look inside of yours and if its bad contact your point of purchase and do not use it.
Also i understand that a upgrade kit is out there with a new board and new led screen-old screen will not work with new board.
Cheers,
Teve
Also i understand that a upgrade kit is out there with a new board and new led screen-old screen will not work with new board.
Cheers,
Teve