Skins_Brew
Well-Known Member
Hey all,
I recently borrowed my dad's oxy acetylene rig because I want to learn how to braze. Anyway, I was brazing some bed frame today and getting the hang of it. Ultimately I want to braze a SS nipple to my SS pot so i can get rid of my delicate weldless setup. Anyway, after gaining a bit of confidence I started messing around on an old SS pot lid. I successfully brazed some copper pipe to the lid with some decent beads but damn did it blacken up the lid. I am using that Harris stay clean flux (paste) and some oatey safe-flo solder. Is there any tips or tricks to do this a bit cleaner? i was watching the below youtube video and this guy is soldering those rings and hardly making any mess. Any advice or tips is greatly appreciated. Thanks!
I recently borrowed my dad's oxy acetylene rig because I want to learn how to braze. Anyway, I was brazing some bed frame today and getting the hang of it. Ultimately I want to braze a SS nipple to my SS pot so i can get rid of my delicate weldless setup. Anyway, after gaining a bit of confidence I started messing around on an old SS pot lid. I successfully brazed some copper pipe to the lid with some decent beads but damn did it blacken up the lid. I am using that Harris stay clean flux (paste) and some oatey safe-flo solder. Is there any tips or tricks to do this a bit cleaner? i was watching the below youtube video and this guy is soldering those rings and hardly making any mess. Any advice or tips is greatly appreciated. Thanks!
Last edited by a moderator: