I really have no clue on how to read electical scematics. Willing to learn though.
I have this timer, for a KAL clone build.
Trying to figure out how to convert the KAL one to this.
http://www.ia.omron.com/data_pdf/data_sheet/h5cx_dsheet_csm100.pdf
page 8.
Terminal Arrangement:
1 (- Power)
2 (+ Power)
Contact output (Think the lines on the page are trying to tell me something)
3 line going up and curved toward #4
4 line goes up 90 degree turn back to 3 then a 90 trun right going upwards till it hit the line from #5
5 up and then 90 degree turn back to #4
6 Input use O V
7 Reset
8 Signal
9 Gate
10-13 Unused.
Would anyone be able to help?
Thanks,
I have this timer, for a KAL clone build.
Trying to figure out how to convert the KAL one to this.
http://www.ia.omron.com/data_pdf/data_sheet/h5cx_dsheet_csm100.pdf
page 8.
Terminal Arrangement:
1 (- Power)
2 (+ Power)
Contact output (Think the lines on the page are trying to tell me something)
3 line going up and curved toward #4
4 line goes up 90 degree turn back to 3 then a 90 trun right going upwards till it hit the line from #5
5 up and then 90 degree turn back to #4
6 Input use O V
7 Reset
8 Signal
9 Gate
10-13 Unused.
Would anyone be able to help?
Thanks,