Just getting everything around for my first go at brewing. My father-in-law upon hearing of my plan to begin brewing offered some used kegs that were just sitting in his garage (he's not a brewer).
He just dropped them off today. I had been thinking I'd need to replace EVERYTHING on them, but the posts and poppets actually look good, I think I might only need new o-rings.
My big question is that 3 are pin lock and 4 are ball lock.... What would you all do in a similar situation? Just buy hoses and disconnects for each system? Can the pin lock ones be converted over to ball lock- and if so, is it worth doing?
Oh and he's bringing up a CO2 cylinder too.
Thanks,
Quinn
He just dropped them off today. I had been thinking I'd need to replace EVERYTHING on them, but the posts and poppets actually look good, I think I might only need new o-rings.
My big question is that 3 are pin lock and 4 are ball lock.... What would you all do in a similar situation? Just buy hoses and disconnects for each system? Can the pin lock ones be converted over to ball lock- and if so, is it worth doing?
Oh and he's bringing up a CO2 cylinder too.
Thanks,
Quinn