samc
Well-Known Member
I had a stand built & my kegs converted by a moron who is oddly enough employed as a professional welder. To cut to the chase, he welded a half coupler for me to hold my thermometer or probe half way up on the keggle. He mounted it flush on the outside over a hole that was not large enough to put a fitting in from the inside if I wanted to. Bits of grain from the mash get caught up in between the wall and the coupler. A real PITA to clean. Not sure how to drill this hole wider to allow for a straight through opening without damaging the threads on the coupler.
Any ideas? - bringing it back to him is not an option as he already screwed up something on the stand that I had complained about. He is a totally FU.
Any ideas? - bringing it back to him is not an option as he already screwed up something on the stand that I had complained about. He is a totally FU.