So I milled the first time with my MM2 2.0 today and had a heck of a time getting the gap stable. The docs say to finger tighten the thumb screws when you have the gap set. So I did that. But then whenever the drill I was using would catch a bit when dumping grain into he hopper, the setscrews would jump out of position and change the gap. So I used a pliers to tighten the thumbscrews down pretty good, which more or less works. But the instruction sheet seems to say that shouldn't be necessary.
So does anyone get the MM setscrews locked in place by hand tightening the thumbscrews, or are pliers always necessary? Also, it seems kinda odd that you have to remove the thumbscrews and thus regap the mill every time you take the hopper off to clean the rollers, or is that what people normally do?
So does anyone get the MM setscrews locked in place by hand tightening the thumbscrews, or are pliers always necessary? Also, it seems kinda odd that you have to remove the thumbscrews and thus regap the mill every time you take the hopper off to clean the rollers, or is that what people normally do?