- Joined
- Aug 12, 2013
- Messages
- 2,066
- Reaction score
- 2,729
I replaced my crapped out mill with this one.
Seems to be a finnicky setup. I'm using a gear motor with pulleys in parity. 164RPM and 60 in-lb.
At first the mill just locked up, but didn't stall the motor.
Then I played with the gap a bit. Have it set at 48. Now the mill spins but doesn't feed the grain through.
Anyone work with this mill and have any ideas?
Seems to be a finnicky setup. I'm using a gear motor with pulleys in parity. 164RPM and 60 in-lb.
At first the mill just locked up, but didn't stall the motor.
Then I played with the gap a bit. Have it set at 48. Now the mill spins but doesn't feed the grain through.
Anyone work with this mill and have any ideas?
Last edited: