winstonofbeer
Well-Known Member
So i am in a hurry to get a 2nd mash tun going.
I was able to get a good seal from inside of the cooler to out for the spigot.
I know i have seen builds where people have used stainless steel water supply lines to use as a manifold on the bottom of the mash tun.
Yesterday at home jipo all they have is now a plastic supply lines...Not stainless steal.
As anyone used this style of supply lines?
I just want to make sure before i cut the end off of a $10.00 supply line and find out it doesnt work
I am using a 30" inch supply line...Figure longer the better.
Typically i would use a copper manifold on the bottom with tons of cuts...but i am pushed for time.
This is also for a square igloo cooler...25L x 13 w x 12d
inside measurements.
This should be big enough to do 10gal batch's easy...
Thanks for your help!
I was able to get a good seal from inside of the cooler to out for the spigot.
I know i have seen builds where people have used stainless steel water supply lines to use as a manifold on the bottom of the mash tun.
Yesterday at home jipo all they have is now a plastic supply lines...Not stainless steal.
As anyone used this style of supply lines?
I just want to make sure before i cut the end off of a $10.00 supply line and find out it doesnt work
I am using a 30" inch supply line...Figure longer the better.
Typically i would use a copper manifold on the bottom with tons of cuts...but i am pushed for time.
This is also for a square igloo cooler...25L x 13 w x 12d
inside measurements.
This should be big enough to do 10gal batch's easy...
Thanks for your help!