Cpt_Kirks
Well-Known Member
The beat up sanke I'm using for a HLT is VERY un-level.
Looks like it has been dropped off too many trucks, the bottom support is badly dished in on one side.
This creates issues with using a site glass. If I level the HLT to calibrate the site glass, then it leans when I use it, I wonder how far off the glass will be?
What would be the best way to level it? Try to put some sheet metal screws in part way, or just make a wooden piece for the bent side?
Looks like it has been dropped off too many trucks, the bottom support is badly dished in on one side.
This creates issues with using a site glass. If I level the HLT to calibrate the site glass, then it leans when I use it, I wonder how far off the glass will be?
What would be the best way to level it? Try to put some sheet metal screws in part way, or just make a wooden piece for the bent side?