bass-a-roo
Active Member
i'm having a lot more trouble drilling through my keg than i had thought i would. I borrowed a 7/8inch unibit (step drill bit) and am using a slow speed and plenty of lubricating oil. How long should it take me to get the right size hole? i drilled a pilot hole through the wall of the keg with a smaller regular drill bit, and now i'm trying to get the unibit to make even the smallest sized hole it can drill but 30 mins of drilling (off and on) i seem to be getting nowhere. Is this normal? how long did it take you to drill through your keg?
ALSO: i'm using a 7.2 volt cordless drill if that makes a difference. (I didn't think it does because i'm supposed to use a slow speed i believe)
ALSO: i'm using a 7.2 volt cordless drill if that makes a difference. (I didn't think it does because i'm supposed to use a slow speed i believe)