Joining Tubing at 90 Degrees Without Welding

[thadius856]

Planning out a project that requires me to join 3/4" or 1" stainless tubing at 90 degree angles. I'm trying to avoid welding if at all possible.

Has anybody used something like these, maybe in inch-sizes and metal?

http://www.themetalstore.co.uk/products/tube-connectors-square

Are there other joinery methods I should consider?

 

[kh54s10]

Where do you plan to use them? In a brew stand? They are nylon and might not take enough weight, they might also melt.

Sorry, no suggestions, just a thought on why they might not be a good choice depending on the use.

 

[b-boy]

You'd have to drill holes, but you might find something here...

http://www.strutchannelfittings.com/316L-Stainless-Steel-_c_49.html

 

[thadius856]

Trying to play this one close to the chest, but I can tell you it's not for a brew stand. Minimal weight and no heat involved.

 

[kh54s10]

Trying to play this one close to the chest, but I can tell you it's not for a brew stand. Minimal weight and no heat involved.

No heat and low weight... They look like they would give a nice finished look without a lot of trouble or cost.