scruff311
Well-Known Member
I put together a HERMS setup for mashing and have been using the Inkbird Itc-308 for temp control of the mash. My biggest problem with it is that the thermometer is very slow to reach the correct reading, especially when compared to my Thermopen. This results in a 3-6 degree increase in a couple of minutes after the set point was hit and the recirculating pump was shut off.
Does anyone have a recommendation for a higher quality thermostat that will read the temperature much faster than this Inkbird device?
Does anyone have a recommendation for a higher quality thermostat that will read the temperature much faster than this Inkbird device?
Last edited by a moderator: