Pash91
Well-Known Member
Hello,
I bought a greenlee punch from Amazon a while back to punch holes for valves. I finally got my pot today and went ahead to punch the hole. The punch started turning on the thread and then got stuck. I've tried everything I can think of to get it to keep threading, but I can't seem to clamp down on the tool hard enough to be able to get it to thread instead of turn. Any suggestions? Did I get a bum tool?
Thanks
I bought a greenlee punch from Amazon a while back to punch holes for valves. I finally got my pot today and went ahead to punch the hole. The punch started turning on the thread and then got stuck. I've tried everything I can think of to get it to keep threading, but I can't seem to clamp down on the tool hard enough to be able to get it to thread instead of turn. Any suggestions? Did I get a bum tool?
Thanks