Nightbrew
Active Member
Ok guys I have got this brutus type rig pretty much put together but I am very dissapointed in the flame. I am running two burner set up w/ the following parts--200,000 btu low pressure 2 stage propane regulator set 11" wc,honeywell 8200's, ball valve, flex line, and finally blichmann burners. I drilled out one the orifices w/a 5/64 bit and the flame on it is a weak yellow flame dancing in the wind, the other burner orifice I left unchanged from its original high pressure set up and have small blue flame maybe a 1/2inch high. It looks good but doesnt seem like it has any ass behind it whatsoever. I am new to the low pressure game and maybe the blue flame is good, but I dont think I can get anything to boil within a day with it, much less the burner that I drilled the orifice out with. I am used to high pressure through these blichmanns and I am starting to think I have made an expensive mistake. What can I start looking at/adjusting to make these burners hum.
Thanks guys trying to get this bad boy going for big brew day on 5/5
Thanks guys trying to get this bad boy going for big brew day on 5/5