legaleagle
Well-Known Member
I was recently gifted a new Corona (or knock off) grain mill. For those of you who have one and have moded it out, I have a few questions:
(1) I want to leave off the handle and attach it to my drill instead (inside a bucket). Is the a standard screw (or something similar) that replaces the handle bolt and will also stay secure in my drill?
(2) In dialing in the crush, about how much of a gap in the plates should I start with before fine tuning?
(3) Will it be stable if I leave off the stinky rubber foot pad (smells pretty bad)? or does the smell go away after a while?
(4) Any other mods I should consider?
Thanks!
(1) I want to leave off the handle and attach it to my drill instead (inside a bucket). Is the a standard screw (or something similar) that replaces the handle bolt and will also stay secure in my drill?
(2) In dialing in the crush, about how much of a gap in the plates should I start with before fine tuning?
(3) Will it be stable if I leave off the stinky rubber foot pad (smells pretty bad)? or does the smell go away after a while?
(4) Any other mods I should consider?
Thanks!