Had this lid fabbed up with a 1.5in tri-clamp welded in, but want to go with a different design. The bail (wire) was reversed to make room for the tri-clamp. This does cause an issue where the black o-ring isn't compressed enough, so it doesn't seal under 0psi. If you put something under the red plastic pieces to increase the clamping force it will seal, or you can add some co2 and that will make it seal as well. It's also a little clunky getting the tri-clamp on and off due to the space constraints.
Just wanted to make it clear that this thing isn't perfect! Happy to answer any other questions. Located in Atlanta but willing to ship at your cost.
Just wanted to make it clear that this thing isn't perfect! Happy to answer any other questions. Located in Atlanta but willing to ship at your cost.
Attachments
Last edited: