Brews and Blues
Well-Known Member
What size is the 16 point star post on the corny keg? I want to get a wrench to get it off, but the two i have ordered have been to big.
You must have one of these. It will remove/tighten both the small (11/16) and large (7/8) 6-point and 12-point posts. $10 on Amazon. I have been using the flat version of this for over 10 yrs. This offset version would be slightly better I think.
https://www.amazon.com/dp/B083S515ZP/ref=cm_sw_em_r_mt_dp_0YRSRZ7FMT0THDBZ20DE
View attachment 717812
and i hope this isn't a pin lock keg! definatly plier time for them!
There is a deep socket specifically made for pin lock posts that have notches cut for the pins.
That wrench is nice.
Husky 1/2 in. Drive 7/8 in. 12-Point SAE Deep Socket-H2D12PDP78 - The Home Depot
I found a 12-point deep socket at Home Depot for about $8. It was the bigger 1/2" socket size, so you'd need the proper ratchet or an adapter.
It also fits the 6-point beer posts on the corny kegs I have, which is nice.
for the record, i just used pliers on one again....
Plus i am a scrawny 150lbs
Enter your email address to join: