markymarx
Well-Known Member
So some months ago I bought a secondary regulator assembly with 3 secondaries so I can serve two and carb one in my kegerator. Looks similar to the one pictured but instead of Taprite's, I am using Cornelius brand.
What is the expected range on these?
Two of the three will go no lower than 11 or 12 PSI on I think a 60 psi gauge.
Third will go as low as 9 or 10 psi.
How low should these go when backing out the pressure adjustment screw before the screw comes out all the way?
If the regulators should go lower, is this a matter of getting rebuild kits for the regulators or would I have to get new springs as well?
They are not leaking. I had them all pressurized and sprayed with Starsan to make sure that was not occurring.
Thanks.
What is the expected range on these?
Two of the three will go no lower than 11 or 12 PSI on I think a 60 psi gauge.
Third will go as low as 9 or 10 psi.
How low should these go when backing out the pressure adjustment screw before the screw comes out all the way?
If the regulators should go lower, is this a matter of getting rebuild kits for the regulators or would I have to get new springs as well?
They are not leaking. I had them all pressurized and sprayed with Starsan to make sure that was not occurring.
Thanks.