kfox527
Member
Hey Folks,
Over the weekend while cleaning my 6.5 gallon carboy in the utility sink I accidentally banged it into the side and knocked out 2 holes! Upon inspection I found the glass to be very thin just above the bottom of the jug. I measured it with a set of calipers and found it to be only about 1 millimeter thick. Is this normal for this piece of equipment? Seemed a bit on the thin side to me.
I've included some pictures below.
-Kevin
http://www2.snapfish.com/snapfish/v...ewReg_30FreePrints_2010Feb/otsc=SYE/otsi=SPNR
Over the weekend while cleaning my 6.5 gallon carboy in the utility sink I accidentally banged it into the side and knocked out 2 holes! Upon inspection I found the glass to be very thin just above the bottom of the jug. I measured it with a set of calipers and found it to be only about 1 millimeter thick. Is this normal for this piece of equipment? Seemed a bit on the thin side to me.
I've included some pictures below.
-Kevin
http://www2.snapfish.com/snapfish/v...ewReg_30FreePrints_2010Feb/otsc=SYE/otsi=SPNR