Gameface
Well-Known Member
I recently rewired my control panel after having to replace the main contactor. Long story short, my amp meter is reading the amps pulled by the pumps correctly, but it's not reading the amps pulled by the heating elements at all. The doughnut is around my two hot legs coming into the panel before they go to the main contactor, just as they were before.
Any ideas what might be happening? I was concerned at first that my heating elements weren't coming on, but that's not the case. The heating elements are working.
This is a drok combo amp and volt meter as seen here http://www.amazon.com/dp/B00DVH64HW/?tag=skimlinks_replacement-20
Weird that it's reading my pumps but not my elements.
I'll post a pic if that's helpful.
Any ideas what might be happening? I was concerned at first that my heating elements weren't coming on, but that's not the case. The heating elements are working.
This is a drok combo amp and volt meter as seen here http://www.amazon.com/dp/B00DVH64HW/?tag=skimlinks_replacement-20
Weird that it's reading my pumps but not my elements.
I'll post a pic if that's helpful.
Last edited by a moderator: