I've received some ball lock gas and beverage fittings, all of which have dip tubes like shown where they don't extend down past the threads. What's the point of this?
I'm installing these in a cap for a Fermonster and want to attach a floating dip tube, but there's no exposed part to do so. I could cut down a full length dip tube, but don't have an extra for that. I could also cut the threads off leaving just enough for the nut to engage. That should give me about 1/4" exposed tubing.
Am I missing something with the standard product shown?
Edit: gas post is shown, but the beverage posts are just the same.
I'm installing these in a cap for a Fermonster and want to attach a floating dip tube, but there's no exposed part to do so. I could cut down a full length dip tube, but don't have an extra for that. I could also cut the threads off leaving just enough for the nut to engage. That should give me about 1/4" exposed tubing.
Am I missing something with the standard product shown?
Edit: gas post is shown, but the beverage posts are just the same.