Attaching DIN rails

[MX1]

Ok, so It is about ti,e to try and wire up my control box. I have all the parts minus a few plugs I need to pick up, but nothing that will keep me from getting started.

My question is this, I am using a 12x12x6 PVC Junction Box for the enclosure, and have a question about securing the DIN rail to it without drilling through the back of the box.

What would be the best way to go about it?

Thanks

Tim

 

[twizted1]

If you can find something to use as standoffs, and to screw to, you can install a plastic backing/back plate in your enclosure. Another option is to install your DIN rail or backing plate using the same screws/bolts that are mounting your box to something.

 

[crazyirishman34]

I think JB Weld would do the trick.

 

[MX1]

I was thinking JB Weld or Liquid Nail

Tim

 

[The10mmKid]

Double sided foam tape.

Try to cover the entire back of the rail.

'da Kid

 

[BigFloppy]

Double sided foam tape.

Try to cover the entire back of the rail.

'da Kid

ALSO, Panduit cable ducting also comes with double-sided tape as well (makes hiding cables easy)