Thanks everyone! OK, so here's what I did. I have 2 batches that need bottling (one this weekend and one next weekend). I have accumulated well over 100 bottles with the help of all of my buddies. I took a 32 gallon sterite container and filled bottles with hot water and placed them upright until the entire bottom was full of bottles. I then took a big scoop of OxyClean and sprinkled over them. I filled the sterite with hot water, put in another scoop of OxyClean and then sunk the remaining bottles into the solution on top of the others. All 100 easily fit in and within 30 minutes, labels were floating on the top. I left them in the tub for 24 hours and with the exception of 2 bottles, not only did the labels fall off, but there were all free of any label glue residue. I only had to scrub 2 bottles out of 100! As I removed each bottle from the solution, I quickly used the bottle brush to ensure that they were free of any residue on the inside, rinsed under hot water and placed them upside down in boxes with a towel in the bottom for draining/drying.
On bottling days, I plan on doing a 10 minute Iodophor soak for sanitization. I plan on filling a spray bottle with the Iodophor solution and spraying down the racks of my dishwasher several times and then placing them upside down over the tines of the racks to drain the solution before filling. Any other suggestions from anyone? Since the OxyClean did such a great job, does anyone think that I should run them through a cycle in the dishwasher before sanitizing in Iodophor?
This is my first bottling experience, so any other tips are greatly appreciated. Thanks all!