bionut
Well-Known Member
After a few years of moving from a city to another and a baby in my familly i can finally return to my electric brewery.
I was going to make a 3 vessel HERMS system based on Kal's controller, with 100 liters pots (25 gal?). In the meantime i had the oportunity to buy a 160 liters pot ( 40 gal?). Now a have two pots, 160 l and 100 l pot. I will buy another 100 liters pot for the system, but i don't know how to integrate the bigger 160 l one.
What would you do, use the big pot for boiling, HLT or mash tun?
If i make a boiler will the 100 l mash tun be big enough to make enough wort? For smaller and pilot batches i have my 50 liters biab ekettle. I have a lot of friends but not always the time to brew.
The power isn't a problem because i will have 3 phases 380V.
I can buy another 160 liters pot if needed, but i am afraid this way i will be forced to make the third one 160 L too...
I was going to make a 3 vessel HERMS system based on Kal's controller, with 100 liters pots (25 gal?). In the meantime i had the oportunity to buy a 160 liters pot ( 40 gal?). Now a have two pots, 160 l and 100 l pot. I will buy another 100 liters pot for the system, but i don't know how to integrate the bigger 160 l one.
What would you do, use the big pot for boiling, HLT or mash tun?
If i make a boiler will the 100 l mash tun be big enough to make enough wort? For smaller and pilot batches i have my 50 liters biab ekettle. I have a lot of friends but not always the time to brew.
The power isn't a problem because i will have 3 phases 380V.
I can buy another 160 liters pot if needed, but i am afraid this way i will be forced to make the third one 160 L too...