TimpanogosSlim
Well-Known Member
I'm done wiring and have control of my 5cf reach-in freezer, a ConAgra SC-142. It has a Samsung compressor in it, but i can't find any technical diagrams other than the schematic on the back.
When it's on, the condensation and frost only collects on the top 15 inches or so of the interior walls.
What are the chances that i can drill a small hole in the side of the 'hump' so i can push the thermistor through the wall right there?
The original thermostat sensor (gas type) was really small gauge and pushed through a little tube that is way too small for the thermistor that came with the controller - plus I'd like the option of strapping the thermistor to the wall of a keg or carboy.
When it's on, the condensation and frost only collects on the top 15 inches or so of the interior walls.
What are the chances that i can drill a small hole in the side of the 'hump' so i can push the thermistor through the wall right there?
The original thermostat sensor (gas type) was really small gauge and pushed through a little tube that is way too small for the thermistor that came with the controller - plus I'd like the option of strapping the thermistor to the wall of a keg or carboy.