3 way gas line distributor swapping inlet sides?

[Ragman]

Hello, I have a keezer with a 3 way gas line distributor that has the inlet from the regulator on the right hand side and a plug on the left.
My question is, can I swap the plug and inlet barb so the inlet will be on the left instead? This model does have a check valve

Anyone know if this can be done? Thanks.

 

[PCABrewing]

Sounds like it is just a hollow manifold with the check valve(s) in the fittings.
In which case you should be able to do it provided the ports are both the same size/thread, probably 1/4" NPT.
A picture would help a lot.
Or you could just remove the inlet and the plug and see if you can see all the way through it.

 

[Ragman]

I swapped it. You were right, could see right thru to other side. Much happier now