Home Brew Forums > Home Brewing Beer > Electric Brewing > Attaching herms coil in eHLT
Reply
 
Thread Tools
Old 09-21-2012, 05:20 PM   #1
CJBrewVT
Feedback Score: 0 reviews
Recipes 
 
Join Date: Feb 2011
Location: Rutland, VT
Posts: 67
Liked 1 Times on 1 Posts

Default Attaching herms coil in eHLT

How far from the end of the tubing should the ferrules sit? Also I am assuming it is ok to disconnect/reconnect the coil from time to time?
CJBrewVT is offline
 
Reply With Quote
Old 09-21-2012, 10:18 PM   #2
BrothOfVigor
Feedback Score: 0 reviews
Recipes 
 
Join Date: May 2011
Location: Idaho Falls, ID
Posts: 81
Liked 13 Times on 8 Posts
Likes Given: 1

Default

Simply set your compression fitting by inserting your tube all the way into the joint, it will hit a stop. Tighten the compression nut and the ferruls will set themselves, bulging the tube slightly and fixing them permanently in place making a leak proof seal.

Once you've done that you can disconnect the compression nut whenever you would like for cleaning or whatever. Just reattach tightly when reassembling.
BrothOfVigor is offline
 
Reply With Quote
Reply


Thread Tools


Similar Threads
Thread Thread Starter Forum Replies Last Post
TRI-clamp herms coil? Olive Drab Electric Brewing 32 12-10-2013 07:23 PM
HERMS coil placement question nealperkins Electric Brewing 3 06-27-2012 02:46 PM
eHLT recirculation pump mizzourah Electric Brewing 6 02-23-2012 06:35 PM
Looking for a wiring diagram for a EHLT Brefus Electric Brewing 1 08-09-2011 12:47 PM
Do I want an eHLT ? adam01 Electric Brewing 53 08-05-2011 02:37 AM


Forum Jump

Newest Threads

LATEST SPONSOR DEALS