Verio
Well-Known Member
So, I made a batch of Root Beer last week, and I'm noticing that the beer line it dispenses from isn't staying pressurized when attached to the keg. That is, when I pull down on the faucet, a bunch of air spurts out, and then a smooth stream of RB then comes out as it should. I close the faucet, and then when I try another pull, once again sputters out air and splashes RB everywhere, and then smooth pour.
My other faucet does not do this, it stays pressurized and always pours smoothly.
I have to add some additional information as well -
The Gas-In line poppet is malfuctioning. When the gas line is detached, it leaks... but when attached I can't hear any leaking at all.. however it could still be leaking. However, when I pull up on the pressure relief valve, it releases a lot of air, so I don't think it's leaking much at all. Could this contribute to the pressurization issue?
My other faucet does not do this, it stays pressurized and always pours smoothly.
I have to add some additional information as well -
The Gas-In line poppet is malfuctioning. When the gas line is detached, it leaks... but when attached I can't hear any leaking at all.. however it could still be leaking. However, when I pull up on the pressure relief valve, it releases a lot of air, so I don't think it's leaking much at all. Could this contribute to the pressurization issue?