From my reading I've formed an opinion that you run the shortest gas lines possible. In my case, I'm tempted to run them in a manner that I can snake them around the walls (see pic). I want to make all of the lines uniform length so I can take any manifold/regulator tap to any keg in the box without swapping the line.
If I do a set-up with shortest length (but adhering to the rule I can reach any keg) makes the lines about 3.5' long. If I do a set-up where the line runs through guides on the collar I could have lines about 6' long.
So do I "route" the lines for neatness, or clip the lines for shortest distance
If I do a set-up with shortest length (but adhering to the rule I can reach any keg) makes the lines about 3.5' long. If I do a set-up where the line runs through guides on the collar I could have lines about 6' long.
So do I "route" the lines for neatness, or clip the lines for shortest distance