Auber switch issues in a RIMS system

I use Aubert switches in my setup. I like them a lot. Mid batch yesterday, my system died during my mash. I have it wired with a main power switch. That wasn't working so I started there. When I replace the switch, it works again. Could I have fried the switch, as it is rated for 10 amps? That can't be it, can it? Have I provided enough info? I am running 110 through this.

I have had 5 successful batches and using RIMS is luxurious. I hate to regress.

You didn't mention your element size. Are you running more than 10 amps through the system?

I see what I did here. Even the smallest element is too much for this switch. Thanks.