Worm Hose Clamps
- Thread starter Stevorino
- Start date
Help Support Homebrew Talk - Beer, Wine, Mead, & Cider Brewing Discussion Forum:
cdburg
Well-Known Member
I'd look for something else. The "note" on that one reads "Not recommended for use with silicone hose and tube." There has to be a reason for that. Using it with silicone tubing may not be a good idea.
boogyman
Well-Known Member
I've used worm clamps on silicone tubing, you just can't over tighten otherwise they'll dig into the tubing.
fyi.. I picked up a 10 pack of those today at Lowes for $4.00 in the plumbing section.
fyi.. I picked up a 10 pack of those today at Lowes for $4.00 in the plumbing section.
OP
OP
Stevorino
Well-Known Member
I'll just go to HD then -- What are you supposed to use for Silicone Tubing?
boogyman
Well-Known Member
I believe you're *supposed* to use those white plastic clamps.. like these:
Beer Line Hose Splicing Kit for 3/16" I.D. Vinyl Tubing | BeverageFactory.com
it's easier just to use the worm clamps in my opinion though.
Beer Line Hose Splicing Kit for 3/16" I.D. Vinyl Tubing | BeverageFactory.com
it's easier just to use the worm clamps in my opinion though.
- Joined
- Nov 6, 2007
- Messages
- 62,016
- Reaction score
- 6,922
Too bad they don't sell them by themselves.
I use standard worm clamps on my beer and gas lines. Just don't clamp to the point of cutting into the tube. Another good tip is to use 3/16 ID hose with 1/4" barbs. Practically eliminates the need for clamps.
bendavanza
Well-Known Member
He asked about 1/2" tubing.
for 1/2" silicon tubing, I would use these:Austin Homebrew Supply
For the vinyl, which is much stiffer tubing, I get stainless worm drive hose clamps at Home Depot. They are wide and have a nice grip.
for 1/2" silicon tubing, I would use these:Austin Homebrew Supply
For the vinyl, which is much stiffer tubing, I get stainless worm drive hose clamps at Home Depot. They are wide and have a nice grip.
MoRoToRiUm
Well-Known Member
- Joined
- Jun 17, 2008
- Messages
- 1,389
- Reaction score
- 6
I use 3/8 tubing on 1/4 barbs- Look ma, no clamps!
Similar threads
