The Pol
Well-Known Member
- Joined
- Feb 12, 2007
- Messages
- 11,390
- Reaction score
- 118
Epiphany...
I already have a hole and a stopper thermometer going through the wall of my HLT. It isnt needed since I have my A419 controller on that vessel now. SO, I am going to get some polycarbonate tubing and create an "L" that will go through a standard drilled stopper, seal tightly and tada, a perfectly and simple sealing HLT sight gauge! My thought is heating it gently to the point where I can bend it, find a small(er) radius form and bend the 90 deg. angle.
McMaster-Carr
I already have a hole and a stopper thermometer going through the wall of my HLT. It isnt needed since I have my A419 controller on that vessel now. SO, I am going to get some polycarbonate tubing and create an "L" that will go through a standard drilled stopper, seal tightly and tada, a perfectly and simple sealing HLT sight gauge! My thought is heating it gently to the point where I can bend it, find a small(er) radius form and bend the 90 deg. angle.
McMaster-Carr