fishnfever
Well-Known Member
- Joined
- Mar 23, 2008
- Messages
- 461
- Reaction score
- 4
I am working on some ideas for a simple two burner stand. I want to connect two sq14 burners to one propane line. So after looking searching and thinking I under stand how to build a propane manifold I wanted some input now
I was going to change out the jets on my sq14's to these ,
http://morebeer.com/view_product/9620//Burner_Jet_-_1_8_in._x_1_in.
and this
http://morebeer.com/view_product/17266//Jet_Adapter_-_1_8"_fpt_x_1_2"_mtpt
then connect the female end of this line,
http://www.hardwareandtools.com/Bra...male-By-1-2-Inch-Male-By-12-Inch-6912745.html
to the jet adapter and the male end would screw into a 1/2 gas ball valve that is connected to 1/2 black pipe.
The two burners will be mounted to a stand so they will not be moved ounce they are mounted. I like the fact of flexibility of the lines and know that I can hard plump the burners but I don't want to hard plump them.
what do ya think?
I was going to change out the jets on my sq14's to these ,
http://morebeer.com/view_product/9620//Burner_Jet_-_1_8_in._x_1_in.
and this
http://morebeer.com/view_product/17266//Jet_Adapter_-_1_8"_fpt_x_1_2"_mtpt
then connect the female end of this line,
http://www.hardwareandtools.com/Bra...male-By-1-2-Inch-Male-By-12-Inch-6912745.html
to the jet adapter and the male end would screw into a 1/2 gas ball valve that is connected to 1/2 black pipe.
The two burners will be mounted to a stand so they will not be moved ounce they are mounted. I like the fact of flexibility of the lines and know that I can hard plump the burners but I don't want to hard plump them.
what do ya think?