Hi all,
I have a plastic false bottom that I'm trying to use in a 10g home depot mash tun. I previously trimmed about an inch off it (all around) to make it fit in a smaller cooler, but I've had trouble with it popping up and getting clogged. I'm using thick high-temp tubing to run to the spigot. Any thoughts on forcing it to seal properly to the bottom or should I look at alternate approaches?
Cheers,
Jason
I have a plastic false bottom that I'm trying to use in a 10g home depot mash tun. I previously trimmed about an inch off it (all around) to make it fit in a smaller cooler, but I've had trouble with it popping up and getting clogged. I'm using thick high-temp tubing to run to the spigot. Any thoughts on forcing it to seal properly to the bottom or should I look at alternate approaches?
Cheers,
Jason