Judochop
Well-Known Member
If I set my regulator to a certain PSI, should the gauge remain at that level? My understanding is that the gauge is reading the pressure from the CO2 tank and has nothing to do with the pressure inside the keg. Is that not correct? I ask b/c my PSI needle seems to wander while Im away. It seems to wander up to higher PSIs. I then unscrew the pin to drop the PSI level and it takes several twists before the needle begins to move.
Is this a user error, or user ignorance, or do I have a wacked out reg on my hands?
Ive also noticed that the other gauge on my regulator the one which supposedly reads the amount of CO2 in the tank has always been on flat-out empty. Its never budged. (My CO2 tank is not empty. Not yet, anyway.) Could that be b/c of something Im doing wrong, or is the thing just busted?
I went to kegs b/c I want CONTROL!!! But Im losing it. Im losing my precious control. I feel like Im being utterly manhandled by these wicked contraptions.
Heeeellllllp meeeeeeeeee
Is this a user error, or user ignorance, or do I have a wacked out reg on my hands?
Ive also noticed that the other gauge on my regulator the one which supposedly reads the amount of CO2 in the tank has always been on flat-out empty. Its never budged. (My CO2 tank is not empty. Not yet, anyway.) Could that be b/c of something Im doing wrong, or is the thing just busted?
I went to kegs b/c I want CONTROL!!! But Im losing it. Im losing my precious control. I feel like Im being utterly manhandled by these wicked contraptions.
Heeeellllllp meeeeeeeeee