jonp9576
Well-Known Member
so i have been doing some research about the kind of rig i want to build.
i am thinking i want a 3 tiered one along the lines of this setup.
http://www.the-sparkmans.net/Photo Gallery/Brew Stuff/Brew Stand/slides/DSCN2508.JPG
my question is what size steel should i buy. is 2" too big?
also, i was wondering about making the bottom tier able to move up and down so i can have an overall lower height but also raise up my BK to gravity feed into my fermenter.
much like this one
http://i113.photobucket.com/albums/n214/truckmann/Beer/my stand/IMG_0147.jpg
as far as wheels, i want to be able to take off my keggles and have it be kind of light. i plan on putting 2 wheels on one end and tilting it like a dollie to move it around.
thoughts, ideas, measurements for burner stand sizes, steel sizes?
also, if i use 2" box, will a piece of 3" be good for the sleeve for the moving BK stand or should i use something like 2.5"
i am thinking i want a 3 tiered one along the lines of this setup.
http://www.the-sparkmans.net/Photo Gallery/Brew Stuff/Brew Stand/slides/DSCN2508.JPG
my question is what size steel should i buy. is 2" too big?
also, i was wondering about making the bottom tier able to move up and down so i can have an overall lower height but also raise up my BK to gravity feed into my fermenter.
much like this one
http://i113.photobucket.com/albums/n214/truckmann/Beer/my stand/IMG_0147.jpg
as far as wheels, i want to be able to take off my keggles and have it be kind of light. i plan on putting 2 wheels on one end and tilting it like a dollie to move it around.
thoughts, ideas, measurements for burner stand sizes, steel sizes?
also, if i use 2" box, will a piece of 3" be good for the sleeve for the moving BK stand or should i use something like 2.5"