I'm new to automated brewing, and have a question about valves.
I was able to get a couple of Asco 8210G095 valves from a friend who scraps pretty cheap. Anyhow, could I use these to control a couple of BG14 burners?
These valves are 3/4 in, so I'm assuming I'd have to use 3/4" pipe to connect the valves to the propane tank. Could I use 1/2" pipe and just put reducers on the valves?
http://valvesandinstruments.com/sol...id-valve-normally-closed-general-service.html
I was able to get a couple of Asco 8210G095 valves from a friend who scraps pretty cheap. Anyhow, could I use these to control a couple of BG14 burners?
These valves are 3/4 in, so I'm assuming I'd have to use 3/4" pipe to connect the valves to the propane tank. Could I use 1/2" pipe and just put reducers on the valves?
http://valvesandinstruments.com/sol...id-valve-normally-closed-general-service.html