Installing your plug.

Homebrew Talk - Beer, Wine, Mead, & Cider Brewing Discussion Forum

Help Support Homebrew Talk - Beer, Wine, Mead, & Cider Brewing Discussion Forum:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
A

alpine_guy100

Member
Joined
Dec 29, 2011
Messages
19
Reaction score
0
I just cut my hole for my plug in my fermenting bucket, will it be an issue if it is gouged from the hand saw I used to cut it on the inside of the lid. But I did sanitize it after I made the cut, however there is little pieces if plastic like hanging inside.
 
I want to tread lightly here, because I do not want to make you think that there is an infection hiding around every corner. There isn't. But I suspect that, just as things will try to hide in scratches in plastic, things might try to hide in the threads. Do your best to smooth that out, and be careful to clean and sanitize the hole carefully.
 
Ya I did sanitize carefully, most little pieces are gone, still some there, but I cleaned it like 4 times, I think and hope its ok, its my first batch.
 

Similar threads

Dland
Reminder, check and tighten contacts on cords
Replies
1
Views
268
Broken Crow
Broken Crow
D
not really new but I sort of am
Replies
2
Views
475
RM-MN
R
TheMadKing
Coffin Keezer Heat Rejection.. Help!!
Replies
13
Views
801
TheMadKing
TheMadKing
David Coy
Power 1 and/or 2 Anvil Foundries at 240 from a 30 amp 240 spa panel
Replies
4
Views
604
David Coy
David Coy
sweets17
Nukatap Mini wall mount installation and leaking.
Replies
4
Views
501
sweets17
sweets17
InkBird 300

Latest posts

Back
Top