Dustin_J
Well-Known Member
Hi folks,
I need some help getting the propane plumbing mounted to my Brewstand. Basically, I'm using black iron pipe and some 1" pieces of CSST for the plumbing, but I need some clamps or something to attach the B.I.P., which forms the bulk of the plumbing, to the brewstand itself.
I've tried using some pipe clips like these, but they after mocking things up it didn't seem like they'd clamp tight enough to keep the B.I.P. from rotating. Also, these are the only types of mounting hardware I could find at H.D./Lowe's but I may not be looking for the right things.
I've attached a picture below showing the general layout of the stand as well as a side cross-section showing how I'd like to mount the B.I.P. The stand is made out of 2"x2"x1/16" sq mild steel tubing, and there are 3 vertical supports that I'd like to attach the B.I.P. to if possible. The red line represents the B.I.P. section, the green is the CSST, the burners are grey, the black lines by the burners represent some adjustable mounting brackets that I'm making, and the yellow/orange is the sweet fire I'm going to make with my new setup Any help you could provide with hardware or methods of getting the plumbing attached would be appreciated.
I need some help getting the propane plumbing mounted to my Brewstand. Basically, I'm using black iron pipe and some 1" pieces of CSST for the plumbing, but I need some clamps or something to attach the B.I.P., which forms the bulk of the plumbing, to the brewstand itself.
I've tried using some pipe clips like these, but they after mocking things up it didn't seem like they'd clamp tight enough to keep the B.I.P. from rotating. Also, these are the only types of mounting hardware I could find at H.D./Lowe's but I may not be looking for the right things.
I've attached a picture below showing the general layout of the stand as well as a side cross-section showing how I'd like to mount the B.I.P. The stand is made out of 2"x2"x1/16" sq mild steel tubing, and there are 3 vertical supports that I'd like to attach the B.I.P. to if possible. The red line represents the B.I.P. section, the green is the CSST, the burners are grey, the black lines by the burners represent some adjustable mounting brackets that I'm making, and the yellow/orange is the sweet fire I'm going to make with my new setup Any help you could provide with hardware or methods of getting the plumbing attached would be appreciated.