cyfan964
Well-Known Member
Where is the best place to put the sticky fermometer on the carboy?? Does it matter? I am assuming the middle would be ok.
Fermometer question
- Thread starter cyfan964
- Start date
Help Support Homebrew Talk - Beer, Wine, Mead, & Cider Brewing Discussion Forum:
zoebisch01
Well-Known Member
cyfan964 said:
Yeah that should be fine. I would probably place it about 1/3 down, but it really probably doesn't matter that much. Fwiw, keep in mind that during a vigorous ferment that reading may actually be a few degrees lower than your actual wort temperature. It is good though for ballpark readings.
I'd put it on the outside. You can see it better that way.
Sorry.
Sorry.
zoebisch01
Well-Known Member
orfy said:I'd put it on the outside. You can see it better that way.
Sorry.
Lol Orfy.
OP
OP
cyfan964
Well-Known Member
You mean it isn't supposed to go on the inside??? I was wondering why I was having such a hard time trying to figure out how to get it to stick. 
TheJadedDog
AFK ATM
Very funny Orfy.
Seriously though, just make sure it's below the 4 gallon mark and you should be fine.
Seriously though, just make sure it's below the 4 gallon mark and you should be fine.
hinkle
Active Member
Something for resurrecting the dead.
Haven't found a thread on it, how long are yins getting out of a stick on fermometer??
