thehand
Member
- Joined
- Mar 5, 2008
- Messages
- 14
- Reaction score
- 0
I'm in the middle of trying to convert a Coleman Xtreme 70qt cooler into a MLT, using the parts and technique this guy used:
Building a Cooler Mash Tun | BrewMoreBeer
I've run into a little problem. When I removed the drain valve it came with, I broke the inner rubber gasket that came with it, and the hole is too big to get a good seal with the #15 o-rings. I went back to Lowe's to try to find some kind of rubber gasket or washer to get a good seal, but couldn't find anything. I searched the web and these forums but couldn't find a good solution. Any ideas?
Building a Cooler Mash Tun | BrewMoreBeer
I've run into a little problem. When I removed the drain valve it came with, I broke the inner rubber gasket that came with it, and the hole is too big to get a good seal with the #15 o-rings. I went back to Lowe's to try to find some kind of rubber gasket or washer to get a good seal, but couldn't find anything. I searched the web and these forums but couldn't find a good solution. Any ideas?