Okay so I've just finished wiring up my RIMS toolbox as per the RIMS for dummies thread. I used a 1500w element, Auber PID and 25amp SSR. I installed a switch between the SSR and the heating element.
When I turn on my box the element should only run when I have the switch set to the on position, but it seems to be running no matter what and I'm not sure why. I haven't calibrated the PID or run auto tune yet.
Here is a wiring diagram that just shows the PID, SSR, switch and Element. The switch is a 3 way 15/20amp switch I had laying around. What am I doing wrong? Does it have something to do with the SSR?
When I turn on my box the element should only run when I have the switch set to the on position, but it seems to be running no matter what and I'm not sure why. I haven't calibrated the PID or run auto tune yet.
Here is a wiring diagram that just shows the PID, SSR, switch and Element. The switch is a 3 way 15/20amp switch I had laying around. What am I doing wrong? Does it have something to do with the SSR?