garbageman
Well-Known Member
I have my system 90% done and have been testing certain functions. One part I dont understand is cycle during RIMS mash.
This is what I have.
BCS controls elements and pumps.
RIMS tube with a 2500w 240v ULD element
Probe on the end of RIMS tub for reading RIMS state temp
Programming:
Direct on to reach temp for mash water with pump going. Pause for dough in. Then turn pump on to start circulating for 1 minute to get flow and then element on with PID control with setpoint of the desired mash temp. (151)
My question is, when using PID control for with RIMS state, does it cycle the element on and off? If so how much? I've read through the documentation and trying to grasp this part. The rest of the settings on the BCS I get.
This is what I have.
BCS controls elements and pumps.
RIMS tube with a 2500w 240v ULD element
Probe on the end of RIMS tub for reading RIMS state temp
Programming:
Direct on to reach temp for mash water with pump going. Pause for dough in. Then turn pump on to start circulating for 1 minute to get flow and then element on with PID control with setpoint of the desired mash temp. (151)
My question is, when using PID control for with RIMS state, does it cycle the element on and off? If so how much? I've read through the documentation and trying to grasp this part. The rest of the settings on the BCS I get.