Ed_Savage
Well-Known Member
Ok, Im planning my Sanyo 4912 kegerator conversion (two faucet, in the door) for about a week or two from now. I have decided against a tower setup, unless somebody convinces me otherwise. I have everything but the faucets, shanks, and drip tray.
I would like to go "all-stainless", and I am trying to narrow down my choices. I would like to get a few opinions, and suggestions.
For the faucets I have narrowed it down to these two.....
Perlick Forward Seal Faucet SS
or
Vent-Matic Ultraflow Faucet SS
The shanks are a little bit tougher to decide on. I can only find stainless shanks in 1/4" bore. Does it make a big differance if I go to 1/4" instead of the standard 3/16" bore? Input please.
The only shank I have found in 3/16" SS is this one --------> Micro-Matic SS Dual Shank. It looks really cool, but would it be really hard to clean? I like the idea of only having to drill one hole though.
Any suggestions on SS drip trays would be nice too.
I would like to go "all-stainless", and I am trying to narrow down my choices. I would like to get a few opinions, and suggestions.
For the faucets I have narrowed it down to these two.....
Perlick Forward Seal Faucet SS
or
Vent-Matic Ultraflow Faucet SS
The shanks are a little bit tougher to decide on. I can only find stainless shanks in 1/4" bore. Does it make a big differance if I go to 1/4" instead of the standard 3/16" bore? Input please.
The only shank I have found in 3/16" SS is this one --------> Micro-Matic SS Dual Shank. It looks really cool, but would it be really hard to clean? I like the idea of only having to drill one hole though.
Any suggestions on SS drip trays would be nice too.