Hey all,
I have, what I think is probably a pretty unique setup and was wondering how to set it up in BeerSmith so my numbers will come out accurate with as little editing as possible required by each batch.
What I have for a HLT is just a basic bottling bucket, which is probably not all that unique, but my MLT is also a bottling bucket with a normal primary with holes drilled in the bottom allowing the water to filter through it. Basically creating a false bottom. Less than ideal I know, but I'm not ready to throw down $100+ for a cooler, FB/braid, etc. for a setup when I haven't even done a AG brew yet.
I am relatively new and the BeerSmith program seems to be fairly complicated, until you get all of your equipment setup, then is seems pretty straight forward.
Any input would be greatly appreciated.
I have, what I think is probably a pretty unique setup and was wondering how to set it up in BeerSmith so my numbers will come out accurate with as little editing as possible required by each batch.
What I have for a HLT is just a basic bottling bucket, which is probably not all that unique, but my MLT is also a bottling bucket with a normal primary with holes drilled in the bottom allowing the water to filter through it. Basically creating a false bottom. Less than ideal I know, but I'm not ready to throw down $100+ for a cooler, FB/braid, etc. for a setup when I haven't even done a AG brew yet.
I am relatively new and the BeerSmith program seems to be fairly complicated, until you get all of your equipment setup, then is seems pretty straight forward.
Any input would be greatly appreciated.