1/4" bore compared to a 3/16" bore on shank

BrewSwag 728
Homebrew Talk - Beer, Wine, Mead, & Cider Brewing Discussion Forum

Help Support Homebrew Talk - Beer, Wine, Mead, & Cider Brewing Discussion Forum:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
j1laskey

j1laskey

Supporting Member
HBT Supporter
Joined
May 13, 2010
Messages
4,973
Reaction score
14,630
Location
Boston
I recently purchased 2, 4 inch shanks with a 1/4 inch bore and installed them onto my kegerator...I am running 10 feet of 3/16" beer line, but have to make approximately a 2 inch "step up" to the 1/4 bore on the shank. Has anyone found this to be a problem with foaming?
 
Heat the end of the tubing in boiling water, and stretch it over the bore on the shank. No worries!
 
I tried that...no can do....i also try to use a large flat head screw driver to strech the line a little also....
 

Similar threads

U
Checklist for kegerator setup
2
Replies
41
Views
3K
uptheirons
U
U
Beer Lines are 3/16 inside diameter. Change lines or barbs
Replies
3
Views
870
odie
odie
Tommydee
Fridgidaire Gallery French Door Refrigerator Kegerator Build - 5 taps, 2.75” spacing
Replies
9
Views
957
Bassman2003
B
Arbe0
how much beer in 3 gallon carboy?
Replies
7
Views
844
IslandLizard
IslandLizard
XBOXHACKER
Yes, another beer foam thread....
Replies
11
Views
736
IslandLizard
IslandLizard

Latest posts

Back
Top