Love Controller Programming Question

I've got my Love controller installed and programed, and it seems to be working great, with one exception. When the temp clicks up that final tenth of a degree to the set point the compressor comes on. Often however, the readout will drop a tenth just as the compressor is coming on - shutting it off. I've got a parameter set to prevent cycling from occurring, so that's not happening, but this couldn't be good for the compressor. Is there some setting that will keep the compressor on until the temp falls a few 10th's?

Thanks

You could try changing the differential parameter, it's r0 on the TS2. What model do you have?

I have the TSS2.

On the TSS2, SP1 Differential is r1. I think that may be my problem. It was set to 0.1.
I reset it to .5, which I hope will make a difference.

Thanks!