I havn't seen this problem posted yet wondering if anyone can give me some advice...
I have the controler wired in running a 25 amp realy that runs a heating element. it's wired just like the diagram that i have seen posted and as the controler instructions show. 1 and 2 are the probes, 7&8 are the power supply lines in 10&11 are the output circut going to the relay that controls the heating element.
the problem i am having is getting the controler to switch to the no circut to turn on the relay...the controler comes on reads the temp of the probe. but nothing i do will turn on the relay. i have checked the grounds to make sure the ground is good threwout the system.. all seems well..
i'm hoping its just somthing i have set wrong...
any input greatly apriciated...
I have the controler wired in running a 25 amp realy that runs a heating element. it's wired just like the diagram that i have seen posted and as the controler instructions show. 1 and 2 are the probes, 7&8 are the power supply lines in 10&11 are the output circut going to the relay that controls the heating element.
the problem i am having is getting the controler to switch to the no circut to turn on the relay...the controler comes on reads the temp of the probe. but nothing i do will turn on the relay. i have checked the grounds to make sure the ground is good threwout the system.. all seems well..
i'm hoping its just somthing i have set wrong...
any input greatly apriciated...