I bought a bargain fittings weldless valve for my aluminium kettle. Followed the instruction and 2 hours later, I can't get the damn thing properly sealed. There's some water leaking...
I've read many suggestions none of them work so far. I've wrapped 3-4 times the nipple, hand tightened the bulkhead etc. The washer that goes on the inside does not seem flat, that might be the problem. Do you guys have any idea ? I'm brewing tomorrow to make things worse ...
I've read many suggestions none of them work so far. I've wrapped 3-4 times the nipple, hand tightened the bulkhead etc. The washer that goes on the inside does not seem flat, that might be the problem. Do you guys have any idea ? I'm brewing tomorrow to make things worse ...