-MG-
Well-Known Member
I'm building a spunding valve like WortMonger has and looking for help on a plumbing piece:
After getting in a few of the 1/4" parts for the valve, I realized the gas in on my coupler:
http://rapidswholesale.com/beer/couplers/draught-technologies-single-valve-coupler-red-handle.html
Is not even close to right size for 1/4". It is bigger than 1/2" by just a little bit as it wouldn't fit in my T I have now. Anyone know what plumbing I can get to work. Is it something like 5/8" to 1/4"? It would have to be 5/8" female to 1/4" male.
After getting in a few of the 1/4" parts for the valve, I realized the gas in on my coupler:
http://rapidswholesale.com/beer/couplers/draught-technologies-single-valve-coupler-red-handle.html
Is not even close to right size for 1/4". It is bigger than 1/2" by just a little bit as it wouldn't fit in my T I have now. Anyone know what plumbing I can get to work. Is it something like 5/8" to 1/4"? It would have to be 5/8" female to 1/4" male.
